MTX Thunder 81000D Car Audio Amplifier "power amp wont" Questions

...amp itself wont power up. neither the protect light or the power light comes on. is there something special you have to do to get this to work Providing you also ran a ground direct from battery, you ...

amp wont get any power to it the lights wont even come on Check the primary fuse on the positive amp wire usually located near the + battery post. Also check any onboard fuses. If these check OK, make

amp shut off and wont power mtx 12's blue power light is on the speakers wont do anything. the speakers worked for about 6 sec then stopped the transistor that mount to the amps body (heat sink) ...

amp , some cars use relays in thier power antenna turn on set up which require low 500 ma 's . hit the amps turn on post with 12 volts directly from a jumper wire with alligator clips from main poower

...on the amp has power checked it. but the amp wont turn on. previously had an amp hooked up to my truck and it worked fine. but this amp wont even turn on everything is hooked up right. speed ...

...Power Amplifier i plug everything in but it wont turn on. I set up another amp to the same cables and the amp works fine. But then i try and put the kenwood back on and when i plug the power wire in ...

...amp kit(4 gauge power+ground wire and 8 gauge speaker wire and the amp. I have the amp in my trunk between the sub box and the back of the trunk! it is pretty much sealed off in a 2'x2'x4' area. ...

...amp itself. First, disconnect all wires except power, ground and the remote turn-on lead and see if the amp powers up normally. If it still goes into protection, the amp is defective, most likely ...

...amp wont power off i have 2 amps on the same remote wire and the 1 amp shuts down and the 2nd one wont just as of today,untill then it has always worked..????? try hooking the remote wire to just the ...

...the amp explain in better details what is happening if the amp wont power up jump a short wire from the positive on the amp to the remote if this powers it up check youre remote wire for bad ...