Question about Fisher and Paykel Washing Machines
...machine won't spin. With out the rotor on, the shaft turns ok. Put the rotor back on and turn it and it gets slightly stuck with a bit more turning pressure it will continue to turn. Hi your ...
...machine) One way to fix this is to open the unit and try to bend the shaft back to an equal kilter, but bending it back won't fix the problem forever, as the metal will now be weakened an d washing ...
...machine for level. It has to be dead on. After you do this if it still vibrates you either have bad shocks or a bent spider shaft on the back of the drum. Hope the level fixes it because a spider ...
Question about Frigidaire Washing Machines
washing machine tub is out of balance - not just from a heavy load that has gotten out of balance - makes a loud, clunking noise, but does not shut off... The shaft that holds the machine will be bent
...washing machine its dancing on last speed of spin It's very likely you have a bent main shaft. This a major problem and you'll need a skilled Washer repair main, but consider the age of your machine, ...
Question about Frigidaire Washing Machines
...or down during turning, suspect a bent shaft on the drum. In either case, it is a major teardown to remove the drum from the outer drum case. If still under warranty, take advantage! Hope this
Washing machine rocks very hard during the spin Whirlpool Ultimate Care II washing machine rocks very hard during the spin cycle. If the machine is not on a very stable surface...such as ...
...bent pulley trying to pry pump off shaft. What's the deal? Thanks, Rob soak with plus-gas anti seize liquid or similar and place a large block of metal on one side whilst you hit it with a 4lb hammer ...
Question about Washing Machines
...shaft cannot be bent and impeller must be firmly attached to the shaft. If it is bent or loose on the shaft it will not pump properly. If it's solid and straight it should work. Put some petroleum ...
...not loose) and motor-shaft is not bent for some odd reason (very unlikely). Also, are you sure you're installing the belt correctly per model diagram? Did you take off the pulley to install
20 questions posted
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
650 Questions
256 Questions