Question about KitchenAid Washing Machines
...washing machine moves around when spinning - it looks like the drum suddenly moved about 2 inces forward touching the front of the machine. MOst of theparts were already replaced any ideas? the drum ...
Question about Kenmore Washing Machines
...drum in place. Open the back and see where it could have come off. When they move the machine it might have sprung out. Good luck. the long spring in a balance spring it belongs to the rear of the ...
Question about LG Washing Machines
...drum/tub forward and back and see if it moves a lot. Next try to wiggle the drum/tub and see if it moves side to side, up and down. If either, then either drum bearings issue or bolt that holds drum ...
...washing machine Hello, I am having a problem with the above washing machine. When the machine is tumbling the clothes during every cycle, there is a scratching noise. Once the wash is complete, the ...
...washing machine that is about 12 years old. When lifting up the lid you notice the drum is off to the side . Its as if the drum is detached from something. I can move the drum with my hand from one ...
Question about Hotpoint Washing Machines
Machine starts the wash sequence by filling with water but the drum fails to rotate at all though its perfectly free to move by hand, at one point all the lights were flashing above the control switc
Question about LG Washing Machines
washing machine had a burn smell in the drum, first time I ever noticed it. Any help with diagnosing much appreciated! As a good guess, I would say it is your bearing seal. That's about the only thing
...washing cycle - improves with spin especially as speed increases. Your drum is out of line and to check is to remove your rubber front gasket and see whether the drum have more space and any of it's ...
washing machine drum not moving Does the prroggram go forward and give supply to the drum motor after the water loads and the level sensor detects, If so the motor is faulty but if there is no voltage
...quite often the whole machine leaps about ! If your comfortable working on washing machines, and can get hold of spares for your machine, then it isnt too bad a job. Otherwise, call an engineer
838 questions posted
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
256 Questions
168 Questions