Frigidaire GLTF2940ES Front Load Washer "try run cold buzzes" Questions

...run. Seems like the switch to stop the cold water from running in is not working properly. When running a cold wash rinse I can hear the washer buzzing when running water in. When it stops with the ...

...run in and is it hot or cold. If water runs and it is cold try going to a total cold setting and see if you get cold or hot water. Is this a new setup or has it been working and stopped? If new, you ...

...run water to see if it is blocked. Clean the inlet filters. If you hear a buzz but no water goes in the inlet valve needs replacing. If yu use only cold water try swapping the cold hose onto the Hot ...

...run the cycle a bit further it will agitate and spin. I checked the water supply and the screens on the back side. When you put it in fill mode, you can hear a buzz sound. What can I do? you need to ...

Try blowing into the hot water port. If the solenoid is functioning properly air will move freely, if not its stuck. Thanks Chihuahua31 for your latest insight. I happen to have the same type hoses on

...cold hoses & I turned the water on high & watched it run into our shop sink & the hot came out tinted Black @ 1st & then ran clear but it was definitely scalding hot. Cold is running clear though. ...

...cold waster fill started as normal and the drum started to turn. Approximately 20mins into the Cycle error E11 started was reported on the LCD. I assumed that the problem was hot water fill as I ...

...run the machine again. Sometimes after 2 minutes it stops with E70 message; other times it runs fine until it reaches the 35 minute mark and the E70 error starts again. Is this a mechanical problem, ...

...run water through the detergent dispensing cup once. Checked and cleaned filters in both ends of hoses and in machine where the hoses connect to the machine. Ran water through both hoses. Turned ...

...faulty transmission. Also, make sure this machine is not sitting in a cold environment. If it is...run a blow dryer under it for awhile and try again. But really I think the transmission is gone. ...