print head's position. In the example photo the print head is positioned at the left hand side of the platen area. Gently move the print head to the center. Note Be careful to not force the print head
...print head is stuck on the right. tried unpluging usb and power, tried to move print head to center, and checked the back door to see if anything was jammed,"nothing" worked, none of the solutions ...
...print head holder cannot move. This is normally due to a paper jam. Action : Clear the paper jam or whatever is obstructing the print head holder. Reload the paper in the machine correctly and press ...
...print head, unplug the machine from the power source, then move the print head to take out the paper. 7. Close the Upper Jam Clear Cover. 8. Close the output paper tray cover and slide it forward, ...
...down, try and print something. See how far the paper goes through the print cycle before jamming. If it jams when it reaches the print head...clean under the print head and try again. Hope this ...
Question about Kodak Office Equipment & Supplies
...print head assembly will not clear a purge unit if it is jammed with paper, paper clips, push pins, screws, cookie crisp, flower bud pods or the like. And yes I have found all those things in a purge ...
Question about HP Office Equipment & Supplies
jam, but there isn't one. How do I get the carriage cleared? Sounds like a piece of paper (or whatever media you were using) is stuck between the print heads and the platen. Are the print heads in the
Question about Kodak Office Equipment & Supplies
...print cartridges as suggested on site. had paper jam few days ago, but still worked. then just stopped and showed error message. suggestions?. I'm not sure if you tried this, yet, but try the ...
...print After clearing a paper jam (incorrectly by pulling paper out from front), I get no print on paper. Manual indicates incorrect clearing of paper jam may damage print head, and I don't know if ...
Question about Brother Office Equipment & Supplies
...print head reaches the end of its travel and hits the paper jam which you cannot see using the suggested jam-clearing steps. So 1. unplug the printer 2. lift the cover so the blue support on the left ...
65 questions posted
Usually answered in minutes!
1,024 Questions
996 Questions
1,049 Questions
812 Questions
732 Questions