...media and ribbon."Gap" Select when using media with a liner space between die-cut labels or when using tag stock with notches or holes as label length indicators."Mark" Select when using media that ...
it had a ribbon? If you don't use a ribbon, you are using it in Direct Thermal mode. You need to set your driver to use Direct Thermal rather than Thermal Transfer, this is in the settings under Media
...media (and ribbon, if equipped with the thermal transfer option) 3) Calibrate the Media Sensor 4) Press and hold the FEED key for approximately 4 seconds or until 2-3 labels advance. Upon completion, ...
Question about Zebra Office Equipment & Supplies
...media sensor. Make sure you haven't loaded the ribbon through the same slot that the paper enters on the media guide. There is a reflective metal plate above the media that reflects the sensor from ...
...Label but printer show massege check ribbon? kindly go to its main menu and set the media type direct Thermal. or check your printer properties u can change the media from there to Direct
Question about Zebra Office Equipment & Supplies
...the ribbon. Try defaulting the printer and running a Pause test. Does the ribbon tear during the Pause test? try using other compatible ribbon.. maybe your ribbon is not compatible to your media ...
...ribbon sensor. Or, the media is loaded in this position. Check the diagram on the inside of the door to make sure labels and ribbon are installed correctly. If you are not using ribbon, then you need ...
although it's correctly unrolling. After printing the ribbon sticks to the media. What can cause this problem? Set the proper alignment and paper feed options in the printer settings / web console
the correct route to thread the ribbon and media in the upper lid. All zebra ribbons come off the supply hub clockwise (left to right) and the ribbon only goes under one roller prior to the print head
Question about Zebra Office Equipment & Supplies
...media could possibly be loaded incorrectly, making the printer think the ribbon is loaded. The sensor is on the inboard side. There is a metal plate with two resistors on it. The labels need to be ...
41 questions posted
Usually answered in minutes!
402 Questions
235 Questions
259 Questions
211 Questions
195 Questions