...ADF, then open the Feeder Cover. Remove the jammed page from under the roller to the Feeder Cover side. Pull out the jammed document from the ADF. If the document cannot be easily pulled out, proceed ...
ADF, then open the Document Feeder Cover. 4. Raise the Paper Release Lever, then remove the jammed page from under the roller to the Document Feeder Cver side. 5. Pull out the jammed document from the
...Cover (white sheet) (C), the glass of the ADF (A), and the inner side of the ADF (white area) (B) gently. Make sure not to leave any residue, especially on the Platen Glass. Cleaning the ADF Caution ...
...for detecting load paper in the ADF section. Check if there is something that keeping it stuck in that position. You will need to open the cover of the ADF section to do this. Hope it
...adf so i cant use any more my machine It's indicating that the sensor in the top of the scanner has been triggered. Try opening the document feeder tray on top of the printer lid and them gently open ...
Question about Canon PIXMA Office Equipment & Supplies
...cover to the Auto Document Feeder (ADF) and examine the paper sensor switch located in the middle area, just before where the paper enters the ADF. You will be looking for a small peice of paper ...
...ADF motor/gear assembly cover. There's a single screw holding it in. Once you unscrew it, you'll need to pull up on the left side of the cover until it pops upward, then you need to push the cover ...
...ADF folder and wrapped around the rollers when the cover is opened Most probably the rollers are sticky. Try cleaning the rollers with fibre cloth soaked & squeezed dry. Use a blower to clear any ...
...ADF access cover first and check if any broken paper block the paper sensor. If no broken paper found, means the paper sensor is faulty and you replace with new one :)Source:Printer ClinicInstant ...
Question about Canon PIXMA Office Equipment & Supplies
cover of the ADF and look for a rectangular hole with a lever stuck down. That lever should only go down when a paper is placed in the feeder, and sometimes they get stuck in the down position. A bent
2,559 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,594 Questions
1,302 Questions
1,216 Questions