...hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water container firmly into ...
hot water in the tank (whish is what I was doing). If you put hot water in the tank, with the heater on, the water gets boiling hot and then the plastic impeller on the pump expands and the pump shaft
hot water through the system with no detergent to empty out all the residual detergent. Keep running hot water through the system by pressing the button you press for it to spray the water do this for
hot water and sprayed onto the carpet after it had been thoroughly vacuumed to remove as much dry soil and debris as possible. Allow a few minutes dwell time and flush out with fresh clean water. Your
Question about Bissell Vacuums
...hot water to the tank instead it will bypass the heating and work in the meantime best way to unclog after following these steps is there is an airlock in tline turn heat off in parked position and ...
...hot water in it and clean it cuz I was going to have to blow in it, yes, with my mouth. I ran it under hot water for a few minutes and then with hot water in the hole, blew into it. I did this a few ...
...hot water. Replace bucket top and place bucket back into vacuum. Raise the handle until it clicks into place. Fill on board soap/shampoo dispenser by lifting out of chamber on unit and fill with ...
...hot but not boiling water and put a couple tea spoons of salt in then leave this to rest for 10min then switch the vac on and try the trigger and see if the water comes out you may need to hold it ...
...part of handle .i had same problem. flush system with hot water after using Bissel 1699 Pro Heat Clearview Plus- dumps entire load of soap after a few minutes of use and flow indicator doesn't
94 questions posted
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions