Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum "turn steam vac" Questions

Ad

...Vac and Steam'? Edited question from 'van and steam', to 'Vac and Steam'. There is no point. All you will end up with is distilled water and the wand head that smells nice. When water is boiled and ...

Ad

Question about Hoover Vacuums

1 Answer

...steam vac v2 do not have manual on hoover steam vac v2 belt recently broken do not know where to start to get to belt The V2 doesn't use a belt, it uses a turbine to drive the brush block, If brushes ...

Ad

...turn does the steam vac have a belt that drives the brushes? No, there is a turbine that turns the brushes. You can take the top cover off to get to it, open it up and clean it out and then try it ...

Question about Hoover Vacuums

1 Answer

...steam vac will not turn on. I was using the steam vac and stopped to refill the tank and now it will not turn on. I tried 3 different outlets, tried turning it on with the handle released and not ...

...steam And vac don't The spin brushes on my hoover steam And vac don't spin. Either the pin on the brushes that attaches to the motor shaft is broken, or the motor is dead.  Did you check the ...

...steam vac tonight and too much water coming out. once it's turned on, water and shampoo continuously come out underneath until tanks are empty. looks to be leaking from left side bottom as looking at ...

Question about Hoover Vacuums

1 Answer

...steam vac modal # F5915905 Water runs out of bottom even when turned off. And upholstery part don't work ,water won't come out. I can tell you this you need to replace the hoses and seals that run ...

...turn the steam vac over. Using both hands, pull evenly on each end of the brush block. They will pull straight out. But usually it isn't necessary to remove the brushes. Usually the problem is a ...

...steam vac - it operates on air flow. Remove the brush and insert a flat screwdriver into the square hole. If it does not turn, the turbine has seized up and must be replaced. Remember that the brush ...

Question about Hoover Vacuums

1 Answer

steam vac. How do I get it apart? There are screws on the bottom to remove, then near the back on each side, the is a catch to release. Before you turn it over, there is a screw where the water intake

Not finding what you are looking for?
Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum Logo

17 questions posted

Ask a Question

Usually answered in minutes!

Top Hoover Vacuums Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Hoover Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...