Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum "handle track" Questions

...track for the rod in the handle assembly. You will see the rod when you disassemble the handle for the sweeper. Move the on/off switch on the handle assembly a few times and look at the bottom of the ...

...section into the roller? I had burning smell and some visible smoke which I tracked down to the handle area. The mains socket at the bottom of the handle had burned out. When I pulled the plug

...talking about a garage door opener , pull the manual release , drop the door all the way,, with the handle still disengaged,, push the button to drop the door,, latch the handle,, try that , if that ...

...track " when reassembling the handle. Gently insert a small flat screwdriver between the rubber wiring contacts and the plastic tongue wraps around the socket. this tongue which extends from the hose ...

...track and is stuck in a square Hi. If you look at the front left side of machine there is a removeable inspection port it will have 2 coloured buttons you press these in & pull it up to remove. Now ...

...handle will not go down I can see a black spring loaded lever that rides in a track. I can release that black lever and get it to manually lower but when i try to do it the way i am supposed to by ...

...handle back up into the locked position, power off and unplug the Bissell, and look down and see if either of the two belts that make the brushes spin are broken, as a broken belt, or a belt that's ...

...handle and then you can back track the replace the interior hose for the cleaning attachment. There should not be a stop that caused the hose to stretch ad break. The hoses after a while do get old ...

handle is lowered. If it's not doing this, check the clear u-bend at the rear of the machine for obstructions. For guidance on doing this, please see the link to our Support page below: http://www

handle on your vacuum. It may be as simple as one of the wires has come off of the switch. I see this every couple of months on the Oreck's that I work on. If that is not the problem, it could be your