Whirlpool Cabrio HE 4.5 cu. ft. Washer "remove lint washing" Questions

message LD on washer what does message LD mean on the washer L D code meanning long drain. lint causing the problem . and restricting the pump inlet .. remove pump and clean out .. ****

clothes do not dry in the time they should and most time they don't dry. i got my dryer in may of 08 Try cleaning out the lint filter and if that isn't it, check the hose that goes from the back of ...

...on this it square with metal bar across it I believe you remove the lint filter and the rack fits in that opening and the rack will be in the dryer and won't be hit by anything when the drum

...lint filter since it was within reach. This machine works a bit different then other machines. The agitation cycle is dependent upon the basket floating up and disengaging from the drive shaft. I ...

...lint stuck in the pump preventing the water to drain properly or 2) You're using too much soap causing lots of suds also preventing the pump from draining properly. If this is the case, what you need ...

...lint tray/filter. So many 'faults' are caused by blocked filters. The motor is unable to drain all of the water in the allotted time. If you are unsure where the filter is, it is normally behind the ...

remove drain pump which more water will come out so have a wet vac ready. Check inside the pump for coins, lint, etc..., If you find something stopping the pump clean and reassemble and run the washer

...lint tray/filter. So many 'faults' are caused by blocked filters. The motor is unable to drain all of the water in the allotted time. Because I do not know your machine I am guessing that the filter ...

remove a few coins in the lint trap. Ran the machine once this morning and it drained fine. Ran it again and we got the LD "long drain" code again. Sounded like the pump was running but nothing coming

I remember I had to remove the lint catcher first, then you place the dryer rack in flat with the support wire toward the back of the drum and the dryer rack resting on the lint catcher area. Try that