Whirlpool 3.2 cu. ft. Plus Washer "makes water stand tub washing" Questions

water in the tub, or do you hear water when you turn the tub? if you hear water when the tub turns, it is not water. the stainless drum has a liquid inside it for balancing loads. if this is the case,

...water just keeps coming in the tub, but drains. lift the end of the drain hose see if the tub fills and goes in the rinse cycle if it works you have a syphon problem if so make your drain pipe stand ...

...water level of the washer. Take the drain hose out of the stand pipe or sink and check where the hose needs to be to stay above the washer tub. You might need to increase the height of the stand pipe ...

...water in tub after partial wash of 3 towels, signnal was LD - re-started machine and it stopped with signal FL - machine will not re-start Fl stands for flooded. Either your pressure switch is bad or ...

...water. The reduction in odor, will occur quickly and dramatically. My second tip is to run the washer empty for a quick rinse cycle. Add an entire cup of bleach at the start of the cycle. The bleach ...

...TUB AND HEAR WATER SHAKING INSIDE. Model nums are fine in the store, if it is an oasis or calypso make sure drain hose is not in drain more than 5 inches. If not your pump might be going out or is ...

...stand pipe or wash-tub to the highest water level of your washer, otherwise it will simply drain/siphon out as quick as it fills. I suspect you likely have the hose lying on the floor or shoved into ...

...the drain filter and causing the tub to hold water.  The added weight of the water causes the tub to not turn at the RPMs needed, and sometimes not at all.  Let me know if this

...stand pipe if the washer tub water level is above the height you can position the drain hose. (Different washers can have different high water levels. The only restriction is that the drain pump on ...