... from B- rail & 1/4 watt resistance in coll. ckt. pnp class b driver to B- rail. Hi REBECCADAVIS How did you get on? Need a cricuit diagram? There is one in the back of this manual. regards ...
...watts, min. RMS, driven into 8 ohms at 1 kHz, with no more than 0.8 % total harmonic distortion. Rear channel .................50 watts, min. RMS, driven into 8 ohms at 1kHz, with no more than 0.8 % ...
...them with a grain of salt because it's impossible to produce more audio watts than are consumed electrically (250 total).
Amp protection circuit has been activated 1-check your input cables from connected equipments(cd player or dvd p layer or any other media source). 2-adjust your input signal level(from-10 db to 0 db).
1 speakers from Richer Sounds 18 months ago and now find that the tweeter in both units has failed. The amplifier I am using is rated at 70 watts which is within the range of 15 to 100 watts indicated
My Pyle amp cut off and will not turn on Ensure the device's power switch is on Make sure the device has power connected. Contact Pyle --> 1-888-318-PYLE / 718-535-1800
amp section from the receiver and laying it on the table bench whatever no going from B-C and C-E if any beeb there junk and the driver transistors are also and there are a few resistors that are junk
ohms and watts RMS)?? do you listen to LOUD music through the 5.1 option?? hope this helps, if all else fails buy a new one mate, theyre so cheap. go into panasonic shops and see if they have any left
...watts and impedance of the speakers, and the wattage of your receiver to make sure they closely match. (impedance is calculated in ohms- indicated by an omega symbol written near the wattage rating) ...
...watts (?) if so I am suggesting this sub woofer ...
2 questions posted
Usually answered in minutes!
2 Questions
5 Questions