i need to wire two w 7 svc ten inch subs to a 1 ohm load jl didnt make w7 svc but i will include a wiring schematic from jl for the w7......http://mobile.jlaudio.com/support_pages.php?page_id=145
One four ohm svc sub wired in series to a 1.1 ohm dvc sub = what??? 5.1 ohms.
...wire my SVC 12 w 3 2 ohms to achieve a 2 ohm load on my amp so it remains stable? any help is apprectiated You can't wire a pair of single voice coil 2ohm subs to achieve a 2 ohm mono load. Too bad ...
...wire goes to ground, or to a metal part of your cars body, probably the same point where your Amp is Grounded. The Octane R10 is a Single Voice Coil or SVC. AMP+ to Sub+Amp- to Sub -Use 12 guage
...subs that are 4 ohm svc and a amp that is 4 ohm 2 ohm and 1 ohm stable can I run my speakers down to 2 ohms or will it be bad for the speakers remember dropping ohm load decreases resistance.The ...
...stated in my other answer to you. You can not wire two SVC 2 ohm subs to acheive a 2 ohm load. more than likely you are running your amp at 1 ohm mono and this is why it is clipping and shutting
wire smell out of the ports of the box and they stoped working the amp is 2 to 16 ohms and the subs are 4 ohms is there some way there wired wrong i wired them hot to hot &ground to ground not bridged
...svc, so each sub's voicecoil is 3 OHMS, connecting them in parallel would lower them to 1.5, and your amp is capable of going down to 1.5 ohms. So I would suggest running them in parallel. Speakers ...
...svc. if you wire the 4 ohm sub voice coils in parallel you will have a 2 ohm load for the Image Dynamics sub, the JL sub only being single voice coil will of course be 3 ohm.You cannot connect them ...
7 questions posted
Usually answered in minutes!
19 Questions
11 Questions
12 Questions
2 Questions
5 Questions