Jenn-Air Pro-Style JFC2089H French Door Refrigerator "compressor power" Questions

...power to and from thermostat and to compressor relay. If compressor powered but not running, compressor fault. If compressor running but no heat in condenser, short of gas. If compressor running and ...

...is warm to touch, indicates faulty compressor. take all electrics off compressor and check for continuity thro windings. also check for power to compressor - if no power, indicates fault in ...

...down. Check power to the compressor start relay. If power there suspect compressor fault if compressor hot. If compressor cold, suspect start relay. If no power to relay, suspect control ...

...power is on to the compressor before it can be confirmed. Also checck the resistance from the outside and if there is coil leaking or open. check the capacitor also which can be faulty and will not ...

...power to compressor? . To Decide if Either your compressor is broken inside or the start components are not working properly. Parameters? are as follows and must MUST be true before continuing: 1 ...

...compressor starts. POWER OFF / Unplugged IF after 30 minutes the compressor does not restart.... 1. Read the pins of the compressor to the case of the compressor. No grounds allowed. 2. Read pin 1 to ...

...power at compressor if power than check thermo safety for compressor if good than compressor has an internal problem which will probably require a replacement check the ptc overload or motor start ...

...power as the light still powers on, but the compressor will not run???? any thoughts? replace the ptc overload on the compressor as this has burned out,it powers the compressor and easily unplugs and ...

...power to the compressor but the compressor cant do anything with it because it locked up and its absorbing that power getting hot and then clicking on overload you could try a relay but i don't think ...

...power surge may have damaged the compressor relay. or overload device on the side of the compressor. I would doubt that it damaged the compressor itself. Be aware of the relay and overload device, ...