...fuse holder is the wiring harness.See these links before proceeding: http://031d26d.namesecurehost.com/mwd/safety.txt http://031d26d.namesecurehost.com/mwd/disassembly.txt You can find helpful ...
Question about Magic Chef Microwave Ovens
...There is a harness that is no longer connected(possibly loosened when the fuse was replaced) There are bad relays on the control board The touch panal is not giving the command to the Control ...
Question about GE Microwave Ovens
to replace the fuse inside the microwave, it should be by the place where the cord goes in the microwave. ok but theres no information on what the fuse may be and its soldered into the wiring harness?
Question about Jenn-Air Microwave Ovens
...terminals or wire harness connector). As a general note, it is rare for a fuse to fail by itself. If you find a blown fuse, look for a cause before replacing it. This may prevent wasting another
...when we tried to use it. It finally lost all power. The outlet still has power, but not microwave. without getting inside it , i would tend to believe its the inline fuse just beyond the wire
...fuse. It will not turn on at all. the wiring harness that plugs into the back prongs has the ground wire looking either rusted or burnt. Help!! Nick, How old is your microwave? If it is more than 5 ...
...fuse? location? Hi LMGreen! Sorry for the late response a bit busy at work.. Coming back to the problem.. Solder joints on power control board are cracked and/or burned. Inspect solder connections on ...
...harness, and is a melting allow type, based on heat buildup within the oven. Always replace with a fuse of the same thermal rating. The power fuse is a special type and should only be replaced with ...
Question about Microwave Ovens
...and will not come back on. I have already mad sure I have power to my harness and checked all of my fuses it there a way to test my unit to see if it is shot you just tested it, it does not work. ...
...after unplugging unit,there is only 1 fuse and unit wont run at all if this fuse is bad,then wiggle all the wire harness connections at all connection points,it sounds like a bad connection ...
162 questions posted
Usually answered in minutes!
43 Questions
39 Questions
46 Questions
26 Questions
28 Questions