Gaggia Titanium Espresso Machine "water coming center bottom hole" Questions

...water coming through the pump I've had my rancilio for just a smidge over two years. It's been great. My husband cleaned the machine with the recommended cleaner last week and since then, the machine ...

...water. This is to keep the heater from burning out if the boiler becomes empty. To reset the thermostat, turn the micro casa a leva over. There is a yellow plug near the center of the bottom which is ...

center) and scrub the screens clean. You need to clean all of the really fine holes out so that the water can pass through. To prevent this in the future, use the rinse cycle on the machine frequently

...water comes out all over reusable k cup is flooding. Hole in used k cup is not in center of cup, something wrong with needle Use the $15 reusable Kcup with a rubber seal ring. If the lid is not down ...

...center for free replacement. No charge to you.The company will send you a new one. Are u sure that the water is still not in the reservior? After the partial brew, CAREFULLY check / empty the ...

...water coming into the tray beneath where the coffee comes out, it goes through the brew unit and comes out beneath the unit in a tray where excess coffee grinds shouldbe. the water tray is completely ...

center of the needle, and rotate it, then pull the clip out. Plug the unit back in, and wait until it is ready. Remove the K-cup holder, and run only water through the unit, as if you are making a cup

...water comes up through the center tube to actually wet the grinds and make the coffee. One pot reached this condition months ago, and yesterday the 2nd one (we bought to replace the 1st one) did the ...

...water. (Automatic Grind and Brew) I can't take the bottom off to check for a loose hose because the screws are recessed too far in with star heads. I can't get to them. Help I love this coffee maker ...

...water? Mine was doing this too. You need to tilt the basket so that the blade device hangs toward the center of the basket and you can guide it into the bottom of the K-Cup. (It will be on the edge, ...