...touch anything inside your computer discharge any static electricity by touching the metal on the inside of the tower. The Memory modules Make sure that they are pushed in securely in there slots and ...
Question about Dell Dimension Computers & Internet
2 inch of insulation should be removed from both ends, and the bare ends twisted into a point. For each wire that goes down into a socket hole of that connector, (24-pin ATX main power cable connector
Question about Dell Dimension Computers & Internet
...touch the metal terminal at the end of the wire.All wires going into the main power cable's connector, end in a metal ...
Question about Dell Dimension Computers & Internet
...2 pins where the power switch is connected (with letters PW) and touch both with your screwdriver. If the computer turns on, your switch is bad. Im not responsible if you touch other pins and kill ...
...2 then stops, motherboard may be intermittently grounding to the case.How do i remedy this? Thanks in advance. power to the board but will not switch on Hi there is way to find out First ,disconnect ...
Question about E-Machines Computers & Internet
...2 pin push plug. This should be connected to your mainboard. On your mainboard, the header for LEDs, hdd, power etc, you should see two pins labled power. Switch push plug goes over these two pins or ...
Question about E-Machines Computers & Internet
Emachine W2646--lights blinking on keyboard,pwr lamp on speaker on,power button on tower YELLOW,NO response! unplugged several hours,now dead,as if unplugged! This happened overnight while shut off ...
...Touch and Hold the metal chassis with one hand to make sure you have no static electricity, while handling cables and I/O cards. 1) Check and wiggle all cables and I/O cards. Remove and re-insert the ...
CMOS Error 0193 Just recived IBM Netvista 2292-21u refubished mother board. I keep getting "Error 0193 system security - IBM Embedded Security hardware has been removed". then "Error System Halted". ...
Question about Dell Dimension Computers & Internet
...2 clips and pull one out make sure that do not touch the botton pins of the memory card and look at the lebeling if it is DDR,DDR2 DDR3 and it will say pc 2400 or 2600 that's just an a example if you ...
1,143 questions posted
Usually answered in minutes!
2,074 Questions
1,169 Questions
718 Questions
514 Questions
464 Questions