...loose from the outside, but if you slip your finger inside(try not to smudge the lense), you'll feel a significant ridge. You may be able to pull / pop it off with your finger, or a small handle. 2. ...
...Minolta 10 x 40 binoculars Minolta 10 x 40 5.6 degree binoculars They are too loose and need to be tightened up on the central shaft Is this possible I cant see a way of getting the cover off to ...
...loose. Can I remove the small covers on the arms connected to the centre support and tighten the pin with a screwdriver? Yes , but note that covers are glued so use a pin to lift cover gently . The ...
tighten minolta 10X40 j-B35 Minolta 10 x 40 5.6 B-J35 binoculars are loose how do you remove water tight covering to get to adjustment screw? Cloudynights person says it was very difficult to get the ...
...binocular 25 years old. The hinge is to loose to keep position. must use two hands Does this pair have two parallel tubes with a bridge in between? If it does, then removing the caps at the eyepiece ...
...loose to hold eye to eye spacing/ I have a pair of bushnell 7x35 rangemaster binoculars, They are the Tamron custom style made in the late 1960s. The eye to eye spacing can be too easily changed.I ...
...tighten binocular hinge I dropped the binoculars on a tile floor while they were in their carry-case. When I checked them, I noticed that the hinge on one side had become much looser than the other ...
loose The center "clamp" that holds the 2 monoculars together has started to loosen so that there is a gap between the top and bottom clamp. I cannot see how to tighten them again. I would think there
loose that I must constantly adjust them to keep the separation to match my eyes. How can I tighten the hinge so that it does not move quite so easily? there is a hinge nut at the bottom of the hinge.
I loosed the left eyepiece...now I hear a slight rattling of the lens and I cannot focus. Tighten it.
1 questions posted
Usually answered in minutes!
25 Questions
12 Questions
13 Questions
17 Questions
24 Questions