Question about Dell Dimension Computers & Internet
...MODE Hi Good day!!! Just open you computer up and switch the little jumper on the motherborad that usually says "CMOS CLR" by hooking the 2nd & 3rd pins together. Than turn you computer on and it ...
...normal mode and a second thing if you have forgotten the password. First of all enter into Bios Setup then Security and Reset your password. Second if you have forgotten your password and you need to ...
Question about Dell Dimension Computers & Internet
...jumper moved back to normal, the system should boot up in default mode. Since Dell makes their own motherboards, you will have to contact their support department to find out how to clear the CMOS on ...
jumper bck to normal position. If you can, removing the nickel Battery would be a good idea for 30 sec. Make sure to put it back in. If you're still getting the same beep code, or if it has changed to
Question about Dell Dimension Computers & Internet
...jumper to "slave" (depending on the other computers setup). Next run the anti-virus scanner on the HD to prevent passing the virus to the other computer. Now the files can be read as it is no longer ...
Question about Dell Dimension Computers & Internet
normal ,etc). I have tried the older drive with the jumper on both 'Cable Select' and 'Master Single' setting with the same results. I know the computer boots as a hard
...jumper to MA. however, dvds and multimedia disks cause the computer to shut down immediately when inserted. a blue screen appears with instructions to put the computer in safe mode or shut down (not ...
...mode and d drive worked and e drive gave me the error message. I rebooted and was looking at the properties and then I clicked on the drive and it worked. So I put a different cd in it and it did not ...
...check the cmos battery is good.then enter F1 & load default settiigs in the menu. again the problem comes you can check the bios jumper is in normal mode .if it is in clear mode change to normal
Question about Computers & Internet
...jumper on the motherboard that is in the wrong position for 'normal' PC operations, and will have to be moved to the proper setting as per the motherboard's manual. so you need to look for the ...
406 questions posted
Usually answered in minutes!
2,074 Questions
1,169 Questions
1,075 Questions
718 Questions
514 Questions
