Canon LASER SHOT LBP-2900 Printer "smps checking" Questions

my samsung printer scx-4521 not print this message is paper jam 01 Dear Pl. check the SMPS found under back cover, at the bottom of the smps ther is a sensor and leaver attached on base. Do check the ...

...39;t power up. Possible failure of the main power supply unit which is a switch mode power supply.( SMPS). You need to disconect the power supply to the printer and open the panel to check the SMPS ...

...smps, check the voltage at secondary output. utmost care should be taken with attention of co-worker while checking live circuit. If there is no voltage, check primary component at area of PWM IC ...

Whare can I get the SMPS for CLP600? Suddenly my CLP600 power down and never power up. I pulled out SMPS and Check the voltage at each connector but no power read by multimeter. I checked all ...

...in the +B or the sub voltages. It is important to check the rail votages to the main board , remove SMPS unit an check. see link below for tips on SMPS power supply ...

SMPS is faulty,needs to be replaced,i am located in orissa,INDIA. before replacing check what part is not working like capacitor or anything, it happens that your smps ok but due to faulty parts it ...

printer do not start If you meant that there is no power supply to work it can be a failure of the SMPS. so check this link for tips to repair. Attempt to work on SMPS only if you are familiar with ...

...Turn the printer off and back on to continue. 2. Reconnect the cable between the fuser and SMPS board. 3. Remove the fuser and re-install it. 4. Check the thermostat. If it is defective, ...

...print pending ) on the led Check and Cause: 1. Deformed paper sensor actuator or faulty sensor. 2. SMPS PBA or Main PBA is defective 3. Faulty cables or connectors. Solution: 1. Replace the

...recevieing is ok. Dear The scanner assy. may be jammed or the CCD/CIS may defect(rare case), The smps may have leaky capacitors cusing to fail to attend full load capacity. The scanner assy. may