...remove the print head. 6. Re-seat the print head into the print head holder and lower the print head lock lever until a click is heard. 7. Insert the appropriate ink tank into the slot at the right ...
Question about Kodak EasyShare Office Equipment & Supplies
...head. The tissue will come out covered in ink.Now for the tricky part get an old printer cartridge and remove the label on top that says "do not remove". Under the label you will find a couple of ...
Question about Kodak EasyShare Office Equipment & Supplies
...head is saturated in three places far left,center,and far right side. I removed that sponge piece to descover the felt strip underneath is the same way.Is this normal ??? If not how do I fix it ? ...
Question about Kodak EasyShare Office Equipment & Supplies
...Make sure that you go online to remove and install the new head. www.kodak.com/go/printheadsupport easy to doit. just remove the print head and clean with warm water and dry and then replace.t ...
Question about Kodak EasyShare Office Equipment & Supplies
removing and replacing print head Cannot remove the old print head, I press the releasse, but it won't work. Pls help! Are you pressing in the right place, the release button is up under the upper lip
Question about Kodak EasyShare Office Equipment & Supplies
...remove the ink cartridges. lift the gray tab gently with thumb and index finger of one hand. gently pull the print head up and out with the other hand. install new print head back first, then press ...
...head: first remove the color ink cartridge. there is a button of sorts under a small ledge just above the picture of the finger used for installation. Press FIRMLY here, up towards the ceiling. The ...
Question about Kodak EasyShare Office Equipment & Supplies
...the middle of the print head you will see a small tab (about 1/4 inch wide). Just press that and you will feel the back of the print head release, you should then be able to remove the
Question about Kodak EasyShare Office Equipment & Supplies
remove ink cartridges. There is a bullseye in the middle of the print head. Use a flashlight and you will see a tab at the top just under the lip of the printhead. Push this tub up with your thumb and
936 questions posted
Usually answered in minutes!
1,024 Questions
996 Questions
74 Questions
69 Questions
51 Questions