Thermador PG304BS Gas Kitchen Range "cooling fan air switch" Questions

cooling fan air switch not detected Replace air switch,replace cooling fan,check connections, check P6 on PCB control display. f64 fault code is an issue with the lower oven cooling fan motor and, or

cooling fan running continuously The cooling fan that blows air out just under the control panel is running perminantly - is there a thermostat I can replace? CREDA Kitchen Range -The cooling fan and ...

...cooling fan rotation 4d31 cooling fan on when de-energized 4d41 cooling fan overspeed 4d51 door switch circuit fault In the service manual, there was no "warming drawer" error code listed in the code ...

...the cooling fan is working by feeling for air flow between the front panel and the top of the oven door. If air flow not present suspect the cooling fan or the inline resistor (could be open

...cooling fan error I got the error code 43 on my Thermador oven and after much expense I learned it was something I could have fixed myself.  First, the concept:  there are two cooling fans ...

...cooling fan 9not the one inside your oven) If the appliance switches on again after 15 - 20 minutes then the fault is most likely here. Unfortunately as you have gas the you will need a Gas Safe ...

...can now see cooling fan the air switch screws in diaginal off to the side of fan it sits in front of fan blade when reinstalling vent cover be careful not to push wires into fan balde or pich wires ...

...cooling fan switch and relay board same problem. cooling fan is working and air flow is fine. oven temp sensor ohms out at 1080 at room temp. ???so i don't have a defective new part. i give up- any ...

...cooling fan or the temp sensor. I had started to remove the temp sensor off the back wall of the oven but was unsure where the wire ran to. There is a specific Ohm value it should have around 1080 I ...

...in or under oven have a small fan in the back which blows while on and when cooling down. If yours is on all the time I would suggest a thermo switch is faulty and stuck on. See the handbook or