Pyle Dryver PLAD213 Car Audio Amplifier "amp power" Questions

...750 rms like a kicker 1500.1 amp? Also how do u know the Rms on this amp? RMS(power) = peak(power) * .707 find the peak power of your amp and use the above formula It will have enough power to do

...power the amp up then without the fuse and then blow the power supply. The pop and smoking inside your amp was most likely your power supply fets. I can repair the amp for you, shoot me an e-mail. ...

...amp power up normally if you connect power and ground and then apply remote voltage (turn the head unit on)? It sounds like an internal problem. you may have some power transistors that are shorted, ...

...Amp has no power. My Amp has no power, no power led, i have tested the power to the amp reading 12.3 volts not sure if this is terminal???? check the fuse of your amp,then the wiring must specially ...

power to the amp, REM terminal is connected to 12V, but led is not on and amp is off too. i didn't notice any burned up areas or power transistors nor visible damage on pcb. thank you for response You

power at the amp; test the power wire at the amp. If there is power at the amp; check for a good ground at the amp.Check for fuses at the amp. If you have power and ground at the amp, the issue may be

...amp will only power up when the head unit is on. 4 Remember to run the signal (speaker) wires in a chase separated from the amps power wires, so as to avoid a buzzing noise in the speakers. 5. Always ...

...power to the amp i touched the power wire to the side of the amp i touched my power wire to the side of my amp on accident. Right above the part where the power wire goes i sliped on my tail gate and ...

...amp has no power the sony amp i got has no power running to it i cheched all the power wires and there good i also looked at all the fuses and there in perfect condition is there a power light on the ...