...flame or main gas. You coud have 24v there without gas flowing or flame if is is a thermocouple standing pilot system and the gas valve is not in the 'on' position. But standing pilot systems usually ...
Question about Sterling Heating & Cooling
off or gas supply pressure too low. 2. Flame sense rod contaminated or loose wire. 3. Gas valve switch is off or wires are not connected. 4. Broken or cracked porcelain on flame probe or spark ignitor
Question about Desa International Heating & Cooling
gas valves have a flame sensor, which is a metal bulb at the end of a wire. The pilot light heats this bulb, and the valve stays open because there's a flame. If the flame has been out, you'll need to
Question about Goodman Heating & Cooling
gas valve,I have 3 volts from flame sensor. is it the igniton module or sensor? HELP!! Your flame sensor is measured in Millivolts not voltage. Is the flame spreading accross the burners at all? If it
Hi. Replace the flame sensor, if that does not fix the problem, check the thermostats, if it cuts off in ten minutes and then restarts when cooling down, then it is either flame sensor or thermostats
Question about Goodman Heating & Cooling
gas valve. Clean out the flame rail where the flame travels and carefully brush off the flame rod with an old tooth brush. clean flame sensor 95% this is problem: metal rod in front of burner farthest
Question about Goodman Heating & Cooling
...Flame sensor,Gas valve,Gas supply. Replaced Flame sensor, gas vale, Control board,and T-stat. Checked Gas pressure (3.5 iwc), checked flame sensor micro amps (4.0), checked neutral to ground (less ...
Question about Dayton Heating & Cooling
gas flame goes out before it get to the right temp only 1 yr old gas flame does not stay on very long even if we turn the thermastat up high sound like a sensor, flame or h.s. ignitor
Question about Williams Heating & Cooling
...gas flow. the flame sensor is a small metal probe that get hot from a flame. Turn the gas control completely off, unplug it if applicable, and gently clean the pilot nozzle with a toothpick or ...
Question about Goodman Heating & Cooling
...gas furnace and the flame cycles for 4 sec goodman gmp075-3 gas furnace and the flame cycles on but shuts off in around 4 seconds, then tries again and again, etc had to replace the control board due ...
60 questions posted
Usually answered in minutes!
60 Questions
36 Questions
29 Questions
17 Questions
5 Questions