Dyna-Glo D-E36 Infra-Red Wall Mounted Panel Heater "clean propane heater air" Questions

...propane heater. I can not see it but i see black on the walls INCOMPLETE COMBUSTION, MAKE SURE IT IS GETTING ENOUGH AIR, YOU DIDNOT STATE WHAT TYPE, CHECK ANY AIR FILTERS, DUST, CLEAN WITH COMPRESSED ...

propane. What is wrong with it. I have had it for four years. You need to clean it out. Take the wall heater down and use a air compressor to clean out the gas system. Also clean the orifice out. Make

...of it ken WITH PROPANE THEY NEED CLEAN AIR, I HAVE THIS PROBLEM WHEN I USE THEM IN A CRAWL SPACE, TRY TO PUT IT SOME PLACE WHERE IT CAN GET CLEAN AIR, GOOD LUCK PLEASE LEAVE FEED BACK IF THIS ...

40,000 but will not stay lit Did you clean the flame sensor probe? Take a piece of sandpaper or metal file and clean it. Try that.

...clean, no ignition board, pump pressure unknown. The R100 is a kerosene heater and the RLP100 is a propane heater so I am not sure when one you have. If it is kerosene then you may need to check the ...

...goes out as if it wasn't getting any propane. check the flame sencor is clean and in postion pressureswitch could be blocked , try jumping out pressure switch see if it lights , check tank is full

out the orifices and the injection tube. That will clean everything out. This may also be a propane pressure problem. Try cleaning it first and then check the inches of water on propane or natural gas

heater acts like out of gas but I plennty It snowing so I went and cleaned the snow off the tank as some one said . What can I do other than that The propane tank could be overfilled. Loosen the bleed

clean. And do not even get close to the hot surface igniter it is very fragile and will shatter if you even bumb it. i have a propane 5 brick heater it lights and ryns good on low when u turn it up it

propane heater is burning very yellow is there a way to adjust it to make it right? or is that normal No, it's not normal. There are two things that can cause the problem: Low gas pressure or poor air