...forward to remove it from the dryer cabinet. Open the dryer door and remove the two screws from the bottom of the door opening and then the four screws securing the top of the front panel to the ...
...forward. Disconnect the wire to the humidity sensor. Remove the belt from idler and yank the drum out. (The belt goes under the tensioner then over the pulley then release it and the spring holds ...
...forward slightly so that the felt support for the front of the drum is exposed on the top of the door opening. You may have to push the top of the drum towards the rear of the dryer. Now pull up on ...
...forward slightly so that the felt support for the front of the drum is exposed on the top of the door opening. You may have to push the top of the drum towards the rear of the dryer. Now pull up on ...
...forward slightly so that the felt support for the front of the drum is exposed on the top of the door opening. You may have to push the top of the drum towards the rear of the dryer. Now pull up on ...
forward and lifts up. With the screws out, the side panel lifts up to remove. Remove the connectors from the control board (might want to mark the white ones; the others are keyed), and the screw from
...wire and door switch connector plug. Without the door switch connected, the dryer will not run. Lower the top panel back in place and reinstall the two screws. NOTE: Placing a piece of duct tape over ...
forward while balancing its weight, and remove it from the dryer housing. Take the old belt and any information from your dryer to an appliance parts supplier to match it for a replacement. Some dryer
100 questions posted
Usually answered in minutes!
1,123 Questions
940 Questions
790 Questions
215 Questions