...hard drive On the acer hard drive the cable is about 1/3/ the size of the cable for my Western Digital hard drive.I can not add my Western Digital to my new computer with the acer hard drive.Is there ...
...HARD DRIVE NEED JUMPER SETTING.WONT GO INTO STANDBY MODE, REBOOTS ITSELF Set The Jumper Setting On Your Hard Disk DriveThe hard disk drive will be detected as 32 GB if the jumper is set to the 32 GB ...
Question about Buffalo Technology Computers & Internet
...hard drive. When your Seagate external hard drive is not working properly, you might ready to send it into the company for repair. Before you send it away, you can troubleshoot the problem and ...
Hard Drive I have 3 different hard drives - two of them state that primary and secondary disk drive can not be found, one says diskette drive seek failure...any thing I can do to fix this? can't even ...
...hard drive then the jumper settings are marked on the circuit board. MA = master SL = slave CS = cable select If this hard drive is the one installed on the Primary IDE controller the the jumper has ...
hard drive, when connected to cable the green light on the power supply lead/ black box flashes, but the drive will not start?? When you disconnect the power supply cable from the hard drive the green
Question about Samsung Computers & Internet
hard drive a SATA (Serial ATA, a thin cable) or IDE (a fat, usually gray cable)? If your hard drive is a SATA, be sure that the both the power and data cables are securely connected to the hard drive
hard drive, AND you will have to set both hard drives jumpers either to cable select or one Master and the other one Slave, based on which one you have the operating system. Instructions Things You'll
Question about Fujitsu Computers & Internet
...Hard Drive" Problem Now! Is this an SATA drive? What kind of enclosure and cable do I need? This drive is an IDE/ATA hard drive. To use this as an external hard drive, I suggest you purchase an USB ...
Question about Maxtor Computers & Internet
...hard drive in the desktop computer, and this is going to be the boot disk then the jumper should be set to MA (Master) and the drive should be connected to the end of the data cable and the other end ...
35 questions posted
Usually answered in minutes!
119 Questions
24 Questions