Husqvarna WE261 960220007 26 190CC Weed Eater Rear Engine Rider Mower "mower engine surges" Questions

...mower surging The engine on my MTD riding lawn mower surges when running. The surging began after 90 minutes of steady mowing after filling the gas tank. The surging goes away under load or moderate ...

...Mower engine surges I have a John Deere GX85 Riding Mower that ran fine last year. This year I find that the engine is constantly surging, and when I idle down the engine stalls. Where to from here? ...

...engine on my riding lawn mower to surge and not stop the surge? Usually when the engine is surging the govener spring is worn. I would get a can of carb and choke cleaner and with the engine cold ...

...the engine, the govenor surges, causing the engine to surge. This is fuel starvation, check inline filters, check the brather in the filler cap, remove float bowl and blow out main jet with air

...mower with a 747 cc Kohler engine, the motor has 9 hours on it but the engine surges at anything but wide open you need to adjust carb on the side of carb there is a mixture adjustment screw on slow ...

engine surges after warm I have a older 10.5 tecumseh snowblower sears model.seems to run good for 5 to 10 min till the engine is warm then it will start to surge at any engine speed.Still has gas ...

...mower starts and dies within a few seconds Anytime u feel surging and the engine dies out , %99 percent of the time it's a carburetor issue. Service the carb and go from there. Searcheck you tube on ...

...engine surging up and down at full trotal and stops runing if trotaled any lower This is on a Craftman rider mower. I have a new gas filter and fuel pump also cleaned air cleaner and new plugs. It ...

...engine surges After mowing I sprayed out the engine with my compressor & now the engine surges in place & when driving Hi, the carby will need to be stripped down and cleaned out as you have ...

...SURGES? It sounds like an idle port may be partially blocked.. the easiest way to clean it is start the engine and cover the carb inlet with the palm of your hand after 2 or 3 times of the engine ...