Samsung WF350ANP Front Load Tumble "water inlet valve code" Questions

...water. The Inlet Water Valve is normal ? The water pressure is very low. ( below 0.5 kgf/ ) Inlet valve is blocked by safety device for leakage sensing.(In case of Inlet Valve). Remedy Open the Water ...

...Water Inlet Valve Fault. Repair or Check - Unplug the washer from power. Reconnect any non secure wires on the water inlet valve. Replace the wire harness if it is found to be damaged. If the wiring ...

inlet valve operation If there is water in the unit: 1. Verify Drain pump operation 2. Pressure Switch Hose is in good condition and properly connected to Tub and Pressure switch Verify there is not a

water inlet malfunction). I've rigged the door switch to let the machine run with door open... On any program the machine drains then let's water in but after a minute or two the error code reappears.

...inlet water hose, it may be plugged. Also check for inlet water screen at the valve. However, if the water is entering into the washer then the Drain pump might not be working. Also inspect the ...

inlet water hoses as they might be plugged. Also check for inlet water screen at the valve. However, if the water is entering into the washer then the Drain pump might not be working. Also inspect the

...the cause. I myself have rarely run into this issue, and when I did, it was mainly caused by low water pressure into the water from the customers water supply, or clogged inlet water valve

...water is on, the inlet filters are not clogged. I have made sure there's no water in the tub. When I cycle the machine on, I can here it trying to fill a couple of times the the HF code comes on. Any ...

inlet valve operation If there is water in the unit: 1. Verify Drain pump operation 2. Pressure Switch Hose is in good condition and properly connected to Tub and Pressure switch Verify there is not a

...inlet water hose, it may be plugged. Also check for inlet water screen at the valve. However, if the water is entering into the washer then the Drain pump might not be working. Also inspect the ...