Whirlpool Ultimate Care II LSQ9564J Top Load Washer "clips hold timer washing machine" Questions

...clips that hold the timer ASM in place broke. The timer still works, and the knob still works. However, because the small clips broke, the knob doesn't "catch" with the timer; it just pushes it ...

Kenmore Washer, Loose Timer Knob I have a Kenmore Series 90 Model 110 Washer with a loose timer knob. The timer itself works fine and when turned with needle nose pliers will run the washer as normal.

hold the control panel to the rear. The timer has a small U clip under the knob that needs to be removed with needle nose and then the knob comes off so the timer can be replaced. I have your washer's

...clips. 3 Turn the knob by hand from one side while looking at the back of the timer from the other side. You should see the timer knob's shaft turning. Grasp the black plastic locking tab in the ...

...wrong way or the wrong spot but that would be a lot of work. Reassemble in the same way you disassembled replace back panel of control panel happy washing. By the way how do you know the timer is

timer console forward and hinge it up. Unplug lid switch connector, remove brass colored clips that are holding cabinet to rear of machine. Opne lid, grasp cabinet and lean forward about 6", then pull

...timer switch( 175D4232P017 ) has become loose and I must hold the switch in place in the back of the panel so that I may turn the cyle part of the switch to the cycle I want and then pull the knob to ...

...clips. Then see the following Whirlpool / Kenmore Service Manual for top load, direct drive washers: ...

...timer (facing the machine). The other side is held in by (you guessed it) a plastic clip molded into the front panel. The clip on the right side was broken, allowing the entire timer assembly to move ...

...clips that hold the timer face panel on. The main control dial must first be pulled off through the front cover, then remove the front cover by unclipping it (a pain and a fiddle!) The dial on the ...