Whirlpool Ultimate Care II GSQ9669L Top Load Washer "gold getting cold" Questions

...Gold top loader. When it gets to rinse, it stops and it doesn't work on the Cold Cold setting only Hot cold or higher (but still has the stop issue at rinse). Cold does not work at all. check cold ...

getting any cold water coming thru, so I think it is the gold water valve that is not working, as this happend before with the hot water valve..only thing is, I have the Washer in the UK, so its 220v,

...gold' washing machine. its an american style top loading 'ultimate care 2' the model number is cm3805688. we only have a cold water feed so we have bought a y conector to conect the hot water pipe ...

...cold settings. My washers currently only washes with hot water. It tried playing with the different settings with no success. Also how can I get a users guide/manual for my Whirlpool Gold Ultimate ...

I go directly to the point. My duet washing machine stuck on C05 when at test mode. Check Amp at the heater = 7.9 Amp. 120 Volt at the heater, heater ohm at 15 Ohm, NTC sensor test at 5,6 K Ohm with ...

...cold hose. is this just a part i can replace? yep pretty easy remove the two screws from the end caps on the back of the control panel pull it slightly foward then tilt it back its on hinges then you ...

...cold water is running under the machine somewhere balogna, You need to get a good look at the fill valve to see whats going on. To do this, remove the two phillip screws on the back side of each ...

...Gold Duet GHW9400P 3.8 Cu. Ft. HT& Ultra Capacity Front-Loading Washer w/ 13 Cycles & 1200... Problem the dyer runs but willnotget hot ! help !!! Symptom: Dryer turns on, drum spins, ...

...gold model number gst9679pwd and its leaking from the bottom guess that if the overflow hose connect to the pump,if not ,normally,if you use high water leverl to wash little cloth,the water will ...

cold. both at start up only go in short birsts and after 15 secunds, the bowl turns only 3-4 centermeters or so it shuts down and beeps I saw the advise from Doctr who said the hall sensor is corroded