Whirlpool Calypso GVW9959K Top Load Washer "getting 4 code electric pressure" Questions

pressure sensor. 3. Reconnect the washer to the electrical supply. 4. Press start and wait 10 seconds (washer will drop out of the continuous loop). 5. Remove the washer from the electrical supply. 6.

4 minutes later the "F/21" error code will be displayed. Press PAUSE/CANCEL two times to clear the display. Possible Causes/Procedure 1. Check the drain hose and make sure it is not plugged or kinked.

code comes on . pushing the stop and start buttons 4 times gets the thing going until the rinse cycle the a you have to push the stop and start buttons 2 times to get it going again. The F1 error code

Getting a H then a F error when the washer is washing a load.... I ended up turning it off. I've also received a F 02 error and a SUD error. Hello, the H and F error means no water is detected ...

...code: LF stands for long fill and occurs when the water level does not change for a period of time after the valves are turned on. All washers are designed to operate with a water supply pressure of ...

Getting flashing code "LF". LF Error code: LF stands for long fill and occurs when the water level does not change for a period of time after the valves are turned on. All washers are designed to ...

Getting an F1 error code on Kenmore Oasis HE top Loader washer ON certain cycles I get a F1 error code. How is this fixed? The F1 error code on this washer indicates a Primary Control Board failure. ...

...getting a LF code. LF Error code: LF stands for long fill and occurs when the water level does not change for a period of time after the valves are turned on. All washers are designed to operate with ...

...getting a code F1 on my OasisHE. It only happens when washer is filling with water The F1 error code on this washer indicates a Primary Control Board failure. It is likely that the machine control ...

...getting a f1 code at various times throught out cycle f1 code The F1 error code on this washer indicates a Primary Control Board failure. It is likely that the machine control board will need to be ...