Question about Washing Machines
timer has 2 motors on a single shaft. Do they ever get out of sync ? if so how do you get them back normal? i have 2 machines that will go thru most of its cycle but when they come to rinse, they stay
Question about Whirlpool Washing Machines
...timer does advance then being 14 1/2 years old it could be the motor. start the washer and mark the beggining where the timer starts. whatch it to see if it moves if not then you need to replace your ...
...2 questions. How does the timer knob come off and also How do you take apart the top to access the timer. Thanks Push the knob to the off position then spin it to the left. it should just screw off. ...
timer in 2-3 times and then it will kick sometimes. Also how do you the timer knob off to replace the timer. I have ordered a new timer , do you think that is the problem. Look if there are any screws
Need to replace the timer hi.. thanks for the question the timer knob unscrews .pull the knob off 2 5/16 screws. remove them timer is free. unplug wiring ,replace timer. thanks the appliance doc
.... pull toward you and lift up to open panel . remove safty clip in center of timer and pulll out red slip pin . this will release timer knob . under the knob is 2 more screws that mount timer .. ...
...- ?20 votes - ?$9.36 - ?In stock This mechanical faucet timer comes with inlet strainer screen and washer. It is very simple to use - just to twist the dial to the desired time (max 2 hours, or ...
Question about Maytag Washing Machines
...2 minutes, timer advances and start over again. I have replaced timer and it worked for one wash, but thereafter same issue. Timer goes to end/stop, drum starts to spin down, but after a minute or so ...
Question about Kenmore Washing Machines
...timer and there were 2 contacts thaat appeared worn with some possibe arcing. I filed them down carefully and replaced, but this had had no effect. Any suggestions - do I need a new timer... Thanks, ...
...clip and sping here , then remove two 5/16 screws , then remove two phillips screws on control panel , you should see 4 ,2 on each side remove the inside 2 then tilt panel forward unplug timer. so ...
2,460 questions posted
Usually answered in minutes!
9,125 Questions
2,624 Questions
1,413 Questions
1,373 Questions
429 Questions