Whirlpool RBD245PDS Electric Double Oven "bad panel" Questions

...bad control panel. If you unplug the ribbon cable from the keypad to the panel then plug the oven back in and it starts beeping again, it's a bad control panel, if it doesn't beep anymore, it's a bad ...

oven lite comes on. Is the control panel bad? Lower oven heats up only The heating element on the top part off oven might be bad or a fuse that's located on back of oven either on or behind back panel

...panel bad or is it the ERC board. From what you say, I think it is the control panel. I looked around for the right one for your model and this is the cheapest one I found online. I know it is no fun ...

...panel and the top of the oven door are badly discolored. I contacted Frigidaire and the solution they suggested, using Mr. Clean Magic Eraser. did not remove the ugly brown discoloration, nor did ...

...panel. Model # JT 950 S0A3SS Hello & Welcome to FixYa F7 error code is displayed when the clock assembly/electronic range control (ERC) goes bad and needs replacement. Sorry for the bad ...

...control switch is faulty, if you can gain access to the control panel, check for bad or burnt connections, unlikely to be board, but not unknown for them to go faulty. Please rate my solution.

...bad gasket that is allowing heat to reach panel. Seems like touch panel just goes wild. Your touch in put key is stuck, replace ,power relay board and the touch panel Always unplug the oven first ...

...bad control board(ERC). Try turning off the power to the oven,remove the front panel. Disconnect,then re-connect the touchpad ribbon. Reapply power and try the controls. Sometimes it is just a bad ...

...controls the oven temp is bad or shorted closed and needs to be changed also the control panel that operates the oven temp could have a bad I C Chip thats went bad and you may need to new control ...

...bad computer board or clock assy. same part.if this a slide in stove with the burners on top there should be a tech sheet on the back,if this is a wall oven there should be a tech sheet below the top ...