battery with a volt meter. If the battery measures lower than 8 volts on a volt meter, replace the battery. I have seen entire cases of brand new batteries that are defective. Make certain to check it
Question about Shure Audio Players & Recorders
...battery with a volt meter to make certain it is above 8.5 volts. I have seen entire cases of batteries that are defective. If the battery checks to be above 8.5 volts and you have removed the battery ...
working. If it uses a 9 volt battery, check both wires going from the 9 volt connector - one might be broke (not connected). Checking if either of the wires is "loose" (broke) is easy. Hope this helps
...Pack display does not show any status messages. Please make certain the battery is good. Put a voltmeter on the battery to make certain it is above 7.5 volts. If the battery does measure above ...
volt battery .. To insert the battery, You will need to unscrew the below button part of the hand held mic (anti-clockwise), and after unscrewing, you will see the space to fix in the 9 volt battery..
Question about Shure Audio Players & Recorders
...volt battery goes i have a shure beta 58a wireless microphone and the mute button is broken it slides up and down without staying in one place and the part where the 9 volt battery goes, the input on ...
Question about Shure Audio Players & Recorders
I have 2 ulx1 microphone transmitters that won't go into set up mode. The power is fine and the display lights up, but is blank. The power light stays red. This happened to both Mics in about the same
Question about Shure Audio Players & Recorders
new. ALSO DO NOT USE rechargeable batteries in these as the rechargeable battery does NOT produce 9 volts... usually only 7.2 volts (in spite of the labeling) which is insufficient and will give a low
...ET9k don't have power to turn on the mic Check AC adapter for proper operation. Input and output voltages should be stamped into the plastic shell of the adapter, with most having a 12 to 24 volt
...volt battery ( the average ni-cad 9 volt is about 200 milliamp hours, not a lot. If so-try switching to nickel metal hydride ( Ni-Mh ) these are better for high drain devices and do not develope a " ...
10 questions posted
Usually answered in minutes!
136 Questions
60 Questions
30 Questions
28 Questions