Whirlpool SF379LEKS Gas Kitchen Range "oven igniter voltage" Questions

...oven igniter, or a failed spark igniter or both. Your oven igniter is the easiest to check. With broiler door open or the plate above your oven burner removed, turn your oven on and look for a red to ...

...oven and you will see the igniter. If you have a voltage meter, You can remove the ignitor from the manifold ans test it. Put your meter leads into the connection and turn the oven on, (ONLY long ...

...stove bottom oven not working Oven not working in lower oven Is there 120V to the igniter? If the voltage is there, but it is not glowing, replace the igniter... GE Range Stove Oven Igniter ...

...oven thermostat.A voltage check at the igniter terminals is needed to decide what is wrong. If you see the glow ,but no ignition chances are the igniter is weak and needs to be replaced (very common) ...

...oven. I replaced the igniter in 10/2011. I'm assuming that's what's wrong again as it doesn't glow. Any other suggestions? Easy to test: 1) pull the bottom drawer out. 2) use a power tester you can ...

...oven igniter was replaced but.... My Ge oven igniter was replaced and it worked fine for 2 months and then the oven stopped working. The technician came back and found that the insulation of the new ...

...oven igniter is glowing. SP303PEPQ2 gas range. CHECK OVEN GAS JETS ARE NOT CLOGED . Change the igniter anyway. As igniters get older, they get weaker. The other thing which sometimes affects this is ...

...oven does not work the broiler does Hi, this could still be a defective igniter, to verify you need a volt meter. The voltage being delivered to the oven gas valve must be at least 3.1 volts ac. ...

...igniter to where it connects to the electronic range control (ERC) board. This a GE, correct? Since this is a GAS oven, I'm also assuming the source voltage is 120VAC. If the circuit board is showing ...

...Oven igniter glows when oven bake is selected but burner will not light. Is bake igniter replacement by owner practical? I would first check the amperage of the igniter. If the igniter is pulling the ...