Whirlpool WED5800S Electric Dryer "removing console panel" Questions

...removing the top panel and the console. Unplug the dryer before servicing. Remove the screws securing the top panel to the rear of the washer and slide the panel to the rear of the dryer. Lift the ...

light wiring harness then lift the front panel off the tabs across the bottom and move it away from the dryer. Reinstall the front panel, the console, and the top cover in reverse of the removal steps

removing the control console (open upper cabinet doors to find screws behind the console). After you remove the control console, the screws along the top of the lower front panel are easily accessible

...console, and the front panel. Disconnect power to the dryer prior to servicing to avoid the risk of electric shock. Remove the top cover by removing the two 10-mm screws attaching it to the rear of ...

...console toward the back of the dryer. Remove the three hex head screws that secure the rear of the top panel to the dryer with a nut driver. The three screws will be on the top rear edge of the top ...

...console over the back panel in its resting position. Use care not to damage the small plastic hinges. CAUTION: Make sure the dryer is UNPLUGGED before servicing. The 220VAC terminals are located in ...

...remove the control panel to gain access. you should have 2 screws at each end of console panel to remove and then pull out at bottom and swain up or 6 screws on back of console and back panel comes ...

...console rear panel to the console and pull the panel off. Inspect the wires connected to the timer and ensure a snug fit connection. Clean the connectors and terminals then reseat it several times to ...

...panel. - Snap the end caps off of the console on both sides. - Remove the two screws that point down in the console into the top - Swing the console up - Remove the 3 screws under the console that ...

...console up and remove three screws holding the top panel down. Slide the top panel toward you and remove. Disconnect light and door switches (top front left.) Remove the toe panel (putty knife on two ...