Question about Kenmore Dehumidifiers
...bad humidistat or a bad PTC relay on the compressor, check for voltage going to compressor, and check neutral continuity, if there is both then you have a bad compressor, check warranty on comp ...
...humidistat to harness, turned unit on and tested the backside of connection on circuit board with volt meter to determine if voltage was passing through connector properly. This would rule out ...
my dehumidifer start and stop often when the humidity reaches it`s set point.???? Hi, the humidistat or sensor has gone bad... heatman101
...it's sounding like the compressor is quitting. IF THE COMPRESSOR QUITS IT WILL NOT PRODUCE MOISTURE COULD BE LOW ON GAS,BAD HUMIDISTAT,DIRTY CONDENSOR CAUSING UNIT TO OVERHEAT SHOULD SEEK ...
humidistat cut in and out then you need to check the power supply if this is ok then it could a few issues 1) compressor on but no dehumidifying ( low on gas or no gas 2) compressor on but no cooling
...bad capcitator? could be but check the power circuit first. power from the cord through the on-off switch, then a thermostat, then a humidistat, any overloads and then the compressor. check the path ...
bad. it should shut off by turning it down. google make and model look for a humidistat appliancepartspro.com is very helpful you can also call them. i replaced mine on a crosley had to disassemble it
Question about Dehumidifiers
...the coils, sounds like it is not getting enough air. Could also be a couple of other things like a bad fan or a bad ...
...humidistat to harness, turned unit on and tested the backside of connection on circuit board with volt meter to determine if voltage was passing through connector properly. This would rule out ...
...DEFROST THEMASTAT, IF SO WHAT IS THE PART NUMBER NEEDED. Either the humidistat is bad and not letting the unit cycle off, there isn't enough humidity in the air, or the condensor coils are too
78 questions posted
Usually answered in minutes!
312 Questions
123 Questions
66 Questions
53 Questions
49 Questions