...beeping noise. After resetting the temp down to 350 to keep from burning a pizza error code FC started blinking along with continual beeping. I have unplugged stove reset breaker etc. but error code ...
Oven not heating up Gas oven turns on, beeps as though its pre-heated, but is barely at 100 degrees (set for 350). Tried setting at 500 and its creeped up a bit to almost 200. Stovetop works fine. ...
Question about KitchenAid Kitchen Ranges
KitchenAid gas range superba not reaching/registering right temp. Set oven to bake at 350. Oven beeps and shows it is preheated to 350. Baked item taking way too long, and oven doesn't feel hot enough
Describe your GE Profile Spectra XL44 Oven Describe your GE Profile Spectra XL44 Gas Oven Problem: The oven takes too long to warm up. Like others, 45 minutes to get to 350. Any gas value to turn? My ...
...beeping. top ranges working ok. I have shut the breaker off for ten minutes, and still same problem. HI, You will need to check the oven sensor wires that link the actual sensor to the main control ...
Oven does not heat to proper temperature My GE XL44 stove does not heat to the proper temperature. I set it to 350 and it maybe beeps when it hits 250. I set it at 450, and I usually get to 350, etc. ...
door on digital oven display trying to turn the oven on and when i push the sart button the display shows a temp setting of 350 and that the on lights up and instead of it going to the pre-heat and ...
oven temp maytag MER5770 set oven temp at 350 & heats up to 155 & stops there. Beeps to advise that preheat is done at 115 degrees. check your element if thats fine u need to replace your erc and ...
Question about Whirlpool Kitchen Ranges
Error F1E2 Whirlpool Super Cap Gas Range 465, oven crazy! Initially began with no "beep" when turning on, then set oven to 350 and I know it was WAY higher as it burned up what I put in. Gas range ...
Oven electronic oven control will not adjust, up and down arrow pads not work - stuck at 350. Is not locked out. That sounds like a keypad problem. Try this: See if the control responds to each button
250 questions posted
Usually answered in minutes!
87 Questions
81 Questions
70 Questions
69 Questions
55 Questions