Eureka 2961AVZ Bagless Upright Vacuum "roller spin" Questions

...spin If your Candery hot dog roller is heating up correctly but the rollers are not spinning, there may be a few different causes. Check to make sure that the rollers are properly lubricated. If they ...

...roller and try to spin it while holding the end caps. If it doesn't spin or spins hard there's your smell. Most times when the rollers go bad they break the belt. Replace the roller if necessary Make ...

...roller is good. I tested it with power source directly to it and it does spin off the vacuum but when I connect it back to the vacuum and turn it on it doesn't spin anymore. It sounds like a break in ...

roller won't spin. It appears that the small roller that should move into place to put tension on the thin belt that would spin the brush roller is not moving into place. Can this be a home repair...I

...spin when you do this. Make sure that the belt is not pinched underneath of the roller brush or this will cause the belt to break immediately when you turn the vacuum back on. Step 6. Reinstall the ...

roller bearings spin freely. If they do not spin freely, put some rubbing alcohol in the bearing (you can pour it onto the bearing and spin the bearing manually until it spins freely, or you can use a

...roller brush. If it does not spin after doing the above steps, then either the belt is slipping or the bearings are severely damaged in the roller brush. Then you need either a smaller belt or a new ...

Roller wont spin The bursh roller will not spin but all other hook up work fine. We just cant get the main vacuum to work... what should we do? is there hair, strings, twine wrapped around the roller?

...roller and the belt appears fine. The toothed rotor doesn't spin, but can't verify if the on-off switch is working either. the pedal on the left turns the brushroll on and off You havE a Windtunnel ...

...roller won't spin and there is verry little to no suction. Still makes all the notice but won't roll as easily You say the belt is not broken and the roller does not spin. Does the motor that spins ...