...screws to undo to replace part. its pretty simple 1. remove 4 screws in the back of phone. 2. remove back cover 3. unclip lcd connector from main board 4. remove main board 5. reassemble with new ...
...Remove the four T-6 screws from back of the phone (you will have to raise the antenna to access one of them) 3. Seperate the housings. 4. Disconnect the flex connector/data cable that connects the ...
Remove your antenna and battery but put your battery cover back on. Step 2: FIRST, open the flip. With the phone facing you (as if looking at your screen), look into the gap between the flip hinge and
...which connects the LCD to the phone. To remove the ribbon, flip back the metal hinge and then simply pull the screen back and the ribbon will be released. Pull the LCD in the direction shown. Take ...
...remove the back cover by gently prying it off with a small flathead screwdriver. Start at the bottom corner of the phone and work your way around the edge until the cover pops off. Be careful not to ...
...remove the adhesive at the back of the keypad interface and you will see the keypad flex connector,if the parts is still ok,gently remove the flex cause it is fitted by a strong adhesive.the you can ...
Question about Motorola Cell Phones
...flip phones is located under the battery. You remove this SIM card by removing the back cover and then the battery. Remove the battery door. Remove the battery. Remove the SIM Mark Motorola ...
...back near the center. Remove this screw. Now flip open the phone the narrow way (not to use as a qwerty keyboard, but rather as a regular flip phone), and you see a covered screw - pry out the cover ...
...flip is closed, no clock, no incomming calls nothing but the backlight I used to be able to see who was calling when my phone was closed. I don't know how it changed. However, I did what I think is ...
716 questions posted
Usually answered in minutes!
2,511 Questions
1,970 Questions
1,815 Questions
1,486 Questions
1,356 Questions
