Cnet CSH-2400 24-Port Ethernet Switch "network cable tester" Questions

...network cable is unplugged. Is this my cable? I have tested the cable with a pin tester that cycles through all 8 pins on both ends to confirm you attached rj45 properly, according to this I get ...

...cable first. You can use the cabe tester. If cale tester is not available then chek the cable with multimeter. 2. Check the port wher you have inserted the patch cord. It should be in uplink port of ...

...network cable unplugged (i have updated all my drivers) You covered half the equation. Now, contact D-Link for their half. No joke. They are usually available 24/7, and will gladly help you, ...

HUB failure I can't get a connection from my hub to my components Are you using the 10Base2 coax outlet, the AIU port or the 8port 10BaseT outlets? Also are you using port #8 which is an uplink port ...

I have a Linksys SRW224G4 connected to a Netgear DG834 ADSL 2 modem 4 port router. It seems to drop the connection every 5 minutes or so. I've checked all the ethernet cables with a tester to ensure ...

...network set up that consists of three UN-managed 3com switches that are interconnected together from one building to the other(each building has its own 3com switch). NOTE: The first building has in ...

...network through the above Hub and I have found that at least two of the machines seem to be dropping connection intermittently. When the connection is dropped there is an orange light that comes on ...

...tester of "0"s and "1's" I agree with stefen V. Before change the domian ID check that zoning were not configured with por-zoning. and also if you change the domian ID it will cause the entre fabric ...

...network is connected. but no ping works. bytes sent and recieved is very less. what may be the problem. when i test the cable with cable tester, it shows fine. More interestingly, When i connect hub ...