...error 6000 and wont print if you remove the transformer block ( the one in witch you insert the power cord... is secured with two plastic restrains ) you may see a small electric drive... engine name ...
...error. You will still be able to print for a short period. To protect the printer from damage, you will not be able to print at all once the ink absorber is full. Canon recommends having the printer ...
...Error Has Occurred when I try to print somethings such as a form? Thanks Ok, i ve found some people who have the same problem they say you have to update your printer driver (perhaps the printer ...
Question about Canon PIXMA Office Equipment & Supplies
...printing when the belt starts to go? We just replaced the transfer roller, the fuser and the exit rollers. xander4265@yahoo.com Hi xander4265: I Streaks in direction of paper travel There are dark ...
...print request. The pop-up prompt suggests turning off the printer and turning it back on. Error 5100 is always seen... manual reset is ok but when pc and printer is turned-off and on again same ...
...printing but a blank sheet of paper comes out with nothing on it, as well as i refill the cartridge blac it still want print and now it reads aligment problems, remove tape from cartridges or check ...
Question about Xerox Office Equipment & Supplies
error has occurred. The following troubleshooting procedures apply to these errors: 13,008.47The Drum Heater is too hot CODE 70.010.43.43 CODE 43.70.11 CODE 04.025.46.7011 CODE 07.008.41.7013 WHAT ARE
Question about Canon PIXMA Office Equipment & Supplies
...print fine and 3 can't. When I use the install disc it goes all the way to the finish but right at the end it says cant finish install an error occured!!! Could it be conflicting with the HP Director ...
...error occurred communicating witht he scanning device. Please ensure that the scanning devise is connected properly and try again. Have changed USB port it was plugged into, unplugged it, still get ...
Question about Canon PIXMA Office Equipment & Supplies
...error after one or two print The flaps will get you to the area that has the issue, but what you need to do is open the back side of the printer; where you can opt to have the finished print come out ...
1,451 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions