...you can wire them to present a 2ohm impedance or an 8ohm impedance. The diagrams are here. If your subs are 2ohm DVC's, the wiring is the same. The impedances will be 1ohm and 4ohms. Hope this
...to 1 ohm wiring the kicker dual coils in parallel (2ohms) and the mtx connected together (4ohms) should leave you with a final impedance between 1 and 2 ohms ...i suggest you use one or get ...
...impedance Of your sub u can't run it @2ohms its going to either be @1ohm or 4ohms and your amp isn't 1ohm stable and u will risk damaging your amp. So your only option is to run it @4ohms and on a ...
...amp; Fiber Glass ConeOkay, now the question is, how would I wire these up to bridge into a amp at 4ohms? Minimum impedance bridged on my amp is 4ohms. wire speakers in series google it to find ...
...4ohms, you simply jumper the positive side of one coil to the negative side of the other coil (series). Connect the remaining terminals to the amp for a 4ohm load. If you wire both positives and both ...
Question about Dual Car Audio & Video
...4ohms wired parallel, this would produce a 2ohm load and alot of "inexpensive" amps will not work efficiently in a 2ohm load since it creats alot of heat! and will cause an amp to shut down. Get your ...
...4ohms to a 1500.1 kicker mono block 1 channel amp, they sound distorted when i turn them up, how should i wire them? Hello antjobe, According to Kicker the 1500.1 is only stable to 2ohms. So you will ...
...impedance of each voice coil is 4ohms. If you wired the coils in parallel, you now have a 2ohm load to the amp. At 2 ohms, the amp tries to produce more power, and even at moderate volume, can be ...
...impedance of both speakers (4ohms) is the same , so that's a match. Actually, the 50 watt speaker may sound a bit better at higher volume, because it will not distort as much as the 15 watt speaker. ...
11 questions posted
Usually answered in minutes!
196 Questions
131 Questions
85 Questions
67 Questions
48 Questions