Whirlpool Gold White-on-White 21.9 cu. ft. Conquest Side-By-Side Refrigerator with Ice and Water GD2SHAXLQ Side by Side Refrigerator "setting freezer temp" Questions

...freezer and refrigerator temp settings wrong? I have frzr temp set a 0 degrees F and refrigerator temp at 37 defrees F. Any suggestions? thanks. It sounds like the freezer has leaking door seals and ...

...setting thats normaly in the middle , wait 24 hours for temps to equalize and check temp in freezer with an accurate thermometer it should be -10 to +10 deg. Far. to adjust temp move dial up or down ...

...temp is + and freezer -, cycle by pressing quick freeze, set temps by up and down temp buttons, once done, push vacation button. your temps are now set, turn the unit off for 2 mins the turn on. ...

...temp for the freezer and refridgerator If you want to set the temperature your Fridge/Freezer should maintain, you need to set the Freezer to between -19c and -23c, however if you will be keeping ...

...be one in the freezer that regulates the temp and this one may be causing the compressor to run continious and you may not be getting the correct reading from freezer. Have you seen this? Sea ...

...freezer at a chosen setting. So the temp at setting 1, setting, 2, ... and setting 7. And When do I use the cool plus button located next to the manual settings button. Only when the temp of the ...

...freezer temp -5 to -1 degrees.several times a day we attempt to set temp to reccommended temp, but no success.we do not have mannual, so not really sure we are using proper procedure to set temp ...

...setting the freezer at 7 opens the baffle from the freezer to the fridge to make the fridge colder.  It works completely opposite than a person would think.  Feel in the back of the fridge ...

freezer then it's best to set the base temp @ -21c minimum, -23 preferable, or the ice cream may begin to break down (very slowly I might add). The Fridge needs to be set to a maximum Highest temp

...temp get below 32 you freezer wont come on and actually begin to get warm (insulation factor) but the refer will seem cold because of the low ambiant temp is the temp inside we go in the refer alot ...