Whirlpool Gold White-on-White 21.9 cu. ft. Conquest Side-By-Side Refrigerator with Ice and Water GD2SHAXLQ Side by Side Refrigerator "freezer setting conquest" Questions

...freezer control) to the COLDEST setting, the refrigerator side freezes and the freezer is too cold. If I turn it up just a VERY small amount the freezer gets warm enough to melt everything and the ...

...setting. Changing them will not work. Is there air blowing from the freezer? The freezer fan may not be working. Or if it is, possibly the air flapper could be stuck closed not letting air flow into ...

Freezer settings what is colder, higher or lower numbers higher

setting the control knob is set at. Yes, the difusser door is not allowing cold air to enter the fridge section, a fridge freezer is actually just a freezer, some of the cold air is drawn off from the

...freezer doors. It is normal for the middle strip to be hot. Did you check the temp setting in the fridge section? Also - you might check for blockage in the bottom. Excessive dirt/dog hair can block ...

...of freezer cub underneat is a must...cloggged drain outlet buildup thick frost on your freezer cub.. .ie..for frost type;you must set your thermostat setting to normal,replace it with new ...

...freezer working.. Check the temperature setting Clean the condensor coils Unplug the freezer, wait two hours and plug it in. If you hear it running, a problem is causing the compressor to overheat ...

...freezer setting display still out. Normally unit technical sheet is hidden for technician reference inside the front bottom kick plate or just under it. Please put it back after using it to the right ...

freezer has too much frost and is running too much the fan is making a noise defrost timer, defrost thermostat, or defrost heater. door seal gone, fan not spinning correctly (may be caused by ice ...

freezer has not been getting to set temp why? Hi, Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If ...