Question about Whirlpool Refrigerators
...auger shaft had moved upward through its stop grommet during all of the yanking to remove the ice bucket. Take off the two hex screws holding the top plate around the auger shaft. The shaft is then ...
...remove the ice bucket and hold the auger it will slip there as well. Top of shaft and notches all appear ok - removed shaft but problem appears underneath that. Any advice? Can you please advise your ...
shaft spins fine. When no ice is in the bucket, the auger and blades spin normally. I then put 5-10 pieces of ice in it and it now has a hard time with it. Could it be a problem in the blades or auger
Question about KitchenAid Refrigerators
to remove the auger shaft so that I can replace the drum? May need to know your entire model # located on the inside in the refrigerator section. That plastic piece may unscrew but be a reverse thread
remove the direct drive drum from the auger on my whirlpool refrigerator ice maker. The replacement manual shows the metal shaft that holds the auger to the direct drive drum is threaded; however, the
...Remove the clear inside cover of the crusher assembly and the "C" clip on the threaded end of the auger shaft to separate the auger from the crusher. And now for my PRIMARY reason for sharing my ...
...piece will not screw off . Remove the panel which holds the motor ( 4 screws ) and disconnect the plug , and the whole panel should come out . Auger motor pt. # WR60X10258 Auger drive pt. # ...
...auger motor will come out together. There is a quick disconnect for the wires.there are boot kits to install over the motors to prevent this or just put it into a plastic zip lock bag with the shaft ...
...auger motor will come out together. There is a quick disconnect for the wires.there are boot kits to install over the motors to prevent this or just put it into a plastic zip lock bag with the shaft ...
...auger...remove cover and auger ....remove spring and large hex shaped shaft. heat the large shaft end with a torch and put it back in hot side toward motor until the motor end is not frozen. No torch ...
16 questions posted
Usually answered in minutes!
1,894 Questions
803 Questions
611 Questions
487 Questions
348 Questions