...or so. you will find the problem area. heat the gasket with the door closed using a hair dryer or heat gun(careful with the gun it will melt if you stay in one spot more than a second at a time) ...
...light switch turns on the dispenser when door is closed if switch is not defective. If the temperatures are increasing in freezer and fresh food compartment it is most likely the defrost heater and ...
...light coat of vasaline all the way aroung the gasket then push the door shut making sure you gasket is touching the door seal all the way around it mat take going over it again with the hair dryer ...
...light on when you open? Then , good news for you , your frreze is in good condition , what you have to do is to unplug it, clean the back , move it 1 foot from the wall and let it stay there . After ...
...light should stay on steady. If you have this scenerio, your emitter boards are working properly. If you do not, check the following: First thing to check is the position of the ejector blades on the ...
...light and cleaned the ice out of it(it was clogged with ice) and used a hot blow dryer in the vent & also down on vent located on shelf by meat drawer just in case those were iced up where i couldn't ...
...dryer. In some models, the vent is located under the temperature control console. The housing either snaps into place or is held in place with screws. Remove the screws, or gently depress the ...
...light to say that the freezer is not warm enough stays on. Can anyone help to say where or what the problem is. This appliance is three years old. We have switched the whole thing off for 12 hours, ...
Question about Whirlpool Refrigerators
...dryer. In some models, the vent is located under the temperature control console. The housing either snaps into place or is held in place with screws. Remove the screws, or gently depress the ...
2,353 questions posted
Usually answered in minutes!
803 Questions
611 Questions
487 Questions
348 Questions
283 Questions