Ionic Pro TURBO Air Purifier "wire ionization filter" Questions

...the green light flashed and then went off. removed the cabinet and saw that one of the ionizing wires was broken (the loop at the end was snapped). I removed all the ionizing wires and cleaned ...

How do I clean the ionizer when the check filter light turns on? with no power to the unit take a soft moist cloth and wipe easy all the wires are flat plates

...those little plastic tabs at the bottom, they aren't important. Their job is to wipe the ionizing wires when you take the grid out or replace it. Hoping the answer is correct and it seems so as the ...

...wire inside the filter collector cell.Clip as short as possible and remove wire.That part of the collector plate will cease to function as that is the ionizer wire but u can resume using the rest of ...

...it push a switch that will give a click you can feel. Keep holding the clip wire down for several seconds. When the red flashes remove the clip wire. The light will stay off if the filter is

...back side of each electrode.  If there is no dust present, did you clean the front ionizing wire on the front grille?  If you remove both front and reare grill, there is also an ionizing ...

Honeywell Air Cleaner Air flow sensor Is the filter clean?  Are the ionizing wires clean?  gently wiping them with 600 grit finishing paper should clean them up and restore perfomrance.Is ...

...filter has been put back in. I have the same problem and haven't been able to fix it. However, others have had the same problem and have posted their solutions. The sizzling sound is caused by ...

...the clean light will not go out. Hi Slipdope... make sure that you are also cleaning the ionizing wire. The wire cleaning mechanism is on top. Just pull up the tab and pull the cleaner up and down ...

...The light comes on, but there is no snapping sound when I push the test button. The cells and wires look ok. What could be the problem. It's possible that the board is at fault. Triple check